Download Print this page

NENKO 28037952 Manual

Led uv blacklight bar 50 cm

Advertisement

Quick Links

1. Name of product
LED UV Blacklight bar 50 cm
2. Product code
28037952
3. Short description
The UV LED bar is a blacklight lamp with LEDs. These have high power, are less vulnerable than
fluores tubes and have a long life. With 9 3-watt UV LEDs.
Size : 50 x 6 x 11.5 cm.
4. Color
As pictured
5. Sensory stimulations
See
6. Safety
Keep this device away from rain and moisture! Unplug before you
open the case!
Never let the power cord come into contact with the other cables! Be careful with the power
cord and all connections to the mains!
Never remove warning or informative labels from the device.
Never use anything to cover contact with the ground.
Never lift the fixture to the projector button, as it can damage the mechanism.
Never place material over the lens.
Never look directly into the light source.
Never leave cables lying around.
Do not connect this device to dimmers.
Do not turn the device on and off with a short break between breaks, this will shorten the life
of the device.
Do not touch the device's housing with bare hands during operation (the housing gets very
bad). Allow the fixture to cool for at least 5 minutes before use.
Do not shake the device.
Avoid brute force when installing or operating the device.
Use the device only indoors, avoid contact with water or other liquids.
Use the fixture only after you have checked that the housing is properly closed and that all
screws are securely attached.
Use the device only after you are familiar with its features.
Avoid fire and do not place the appliance near flammable liquids or gases.
Always keep the housing closed while in use

Advertisement

loading

Summary of Contents for NENKO 28037952

  • Page 1 1. Name of product LED UV Blacklight bar 50 cm 2. Product code 28037952 3. Short description The UV LED bar is a blacklight lamp with LEDs. These have high power, are less vulnerable than fluores tubes and have a long life. With 9 3-watt UV LEDs.
  • Page 2: Maintenance

    • Always provide a free airspace of at least 50 cm around the device for ventilation. • Always disconnect the power supply when the device is not in use. 7. Maintenance The operator must ensure that safety related and machine technical installations must be inspected by an expert after each year in the course of acceptance.
  • Page 3: Put Into Service

    Problem Possible Cause/Causes Solution The tensioning device does No power to the tensioning device Make sure the power is turned on not function at all and the cables are connected Return the device to your dealer Internal fuse jumped No light or LEDs flashing Fixture is too hot Allow the fixture and bring it back occasionally...
  • Page 4 Do not power until the entire system is set up and connected correctly. Always disconnect from the grid's power supply before cleaning or maintaining the appliance. Damage caused by non- compliance is not covered by thewarranty. Set up and operate Follow the instructions below, as they relate to your preferred modeof service.
  • Page 5 Front 1) Attachment bracket with inclination bolt 2) 9 x 3W UV-LED's Back 3) Mounting bracket position crew 4) Aardings- / aardeverbindingen 5) Plug power cable (1.5m) 6) Power switch ON /OFF...
  • Page 6 Metal and flame slowing plastic Aansluitingen: Plug power cable (1.5m) Max. ambient temperature ta: °C Max. behuizingstemperatuur ta: °C Minimum distance: Minimum distance from flammable surfaces: 0,5 m Minimum distance to illuminate the object: For more information, you can visit our website www.nenko.com...