Page 1
LED Light source for Super safe fibre optics. Equipped with ON / OFF and PAUSE button for a fixed colour, switch and USB connection for service purposes. Add a switch from the Nenko Interactive program and wirelessly control the colours of the fiber mist or of all linked Nenko Interactive products in the room. Connection 3 cm diameter.
Page 2
9. Installation Step 1: Carefully remove the packaging from the light source. Step 2: Attach the metal round end part of the fiber mist into the round recess of the light source. Before doing this, make sure that the top screw is unscrewed so that the fiber mist fits properly into the recess.
Page 3
Torques: PINK. The unit is now in “PAIRING MODE”. In this mode it will slowly flash PINK until it receives a pairing signal from the Nenko Interactive Colour Switch (22009). Press again for 7 seconds to cancel “PAIRING MODE” Switch input: Same function as PAUSE / PAUSE button, only performed by play switch with 3.5mm jack connection (not included).
Page 4
11. Related products In combination with the use of the Nenko Interactive Colour Switch Panel (22009), the colour of the light source changes when one of the 6 push buttons on the switch panel is pressed. You can operate multiple items with this switch panel.