Lindy 39385 User Manual page 5

User Manual
Specification
Supports DisplayPort 1.2a (21.6Gbps), HDCP 2.2

Supports USB 1.1

The following distance and resolution combinations are possible when using high quality Cat.6

U/UTP or F/UTP solid core cable:
- 150m: 1920x1080@60Hz 4:4:4 8bit
- 100m: 3840x2160@60Hz 4:4:4 8bit
Supported audio formats:

- 2CH LPCM 32~96KHz
- 5CH Dolby Digital Plus
- 7CH DTS-HD
ESD Protection: ± 8kV (air-gap discharge)

Human Body Model: ± 4kV (contact discharge)

Operating Temperature: 0°C - 40°C (32°F - 104°F)

Storage Temperature: -20°C - 60°C (-4°F - 140°F)

Relative Humidity: 20 - 90% RH (Non-condensing)

Black, metal housing

Power Requirements: AC100-240V 50/60Hz

Power Consumption: 13.2W Maximum

Installation and Operation
Transmitter Front and Rear
1. Power LED: Indicates Power.
2. EDID: Dip switch for EDID setting.
- COPY: copy the EDID from the DP OUT port on the Receiver.
- SDT: 1080P 2CH.
3. SERVICE: Reserved for firmware updates.
4. DC 24V: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the Transmitter
or Receiver. This is only required at one side of the installation.
5. HDBT OUT: Connect the Receiver unit using a single Cat.6 or above cable for all data signals. Please
do not connect to a network port.
6. Link indicator LED (green):
- Illuminating when Transmitter and Receiver are connected.
- Flashing when the connection between Transmitter and Receiver is not stable.
- Not illuminated when there is no connection between Transmitter and Receiver.
7. Data Signal Indicator LED (yellow):
- Illuminating when DP signal is with HDCP.
English