Advertisement
Table of Contents
- 1 Installation
- 2 Step 1: Remove the Belt Guard and the Bolts of the Hitch
- 3 Step 2: Install the Lift Links
- 4 Step 3: Uninstall the Tension Arm and the Pulleys
- 5 Step 4: Install the New Tension Arm and Re-Install the Pulleys
- 6 Step 5: Re-Install the Belt Guard
- 7 Step 6: Install the Snowblower
- 8 Parts List
- Download this manual
LIFT LINKS FOR NORTHEAST SNOWBLOWER #700706
IMPORTANT : Before installing the update kit, follow all safety instructions and indications by
reading and understanding all of the snowblower and the subframe owner's manual.
STEP 1: REMOVE THE BELT GUARD AND THE BOLTS OF THE HITCH:
For this step, position the snowblower in this way to facilitate the
installation.
STEP 2: INSTALL THE LIFT LINKS:
Do the same thing on both sides. Make sure not to reverse the
lift links.
FOR KIT
700706
INSTALLATION
Instructions
N-11
Advertisement
Table of Contents
Related Manuals for Bercomac 700706
Summary of Contents for Bercomac 700706
- Page 1 Instructions LIFT LINKS FOR NORTHEAST SNOWBLOWER #700706 INSTALLATION IMPORTANT : Before installing the update kit, follow all safety instructions and indications by reading and understanding all of the snowblower and the subframe owner’s manual. STEP 1: REMOVE THE BELT GUARD AND THE BOLTS OF THE HITCH: For this step, position the snowblower in this way to facilitate the installation.
- Page 2 Make sure to put the nylon insert lock nut 3/8” n.c. (thin) (item 4) for the pulley installation. Note: Tighten the carriage bolt 3/8” n.c. x 1 1/4” to allow the tension arm to pivot freely. N-11 FOR KIT 700706...
- Page 3 Insert the links (one of each side) in the ends of the actuators and install the following parts in the indicated direction. Note: As needed, extend actuators with the switch to be able to insert the pin N-11 FOR KIT 700706...
- Page 4 N-11 FOR KIT 700706...
Need help?
Do you have a question about the 700706 and is the answer not in the manual?
Questions and answers