Connecting An Adat To The Vsr-880 - Roland VM-7100 Connection Manual

(18) Connecting an ADAT to the VSR-880

• Transferring audio via digital connection between the ADAT and the VSR-880.
• The ADAT can be controlled with the VSR-880's transport buttons such as play and stop.
Connection
fig.18
S
C
T
Equipment required
VSR-880 [internal IDE hard disk installed], DIF-AT, ADAT
Turning on the system
Connect the equipment and then turn the power on in the following order.
ADAT VSR-880
Settings
VSR-880
[SHIFT]+[SYSTEM ( )]
• SYS: MasterClk:
[SHIFT]+[SYSTEM ( )]
• MID:MMC:
[SHIFT]+[SYSTEM ( )]
• Syn:Source:
• Syn:InSel:
[LEVEL/BALANCE]
• MST Direct Out:
[SHIFT]+[IN MIX (LEVEL BALANCE)]
• IN1 (2, 3, ... 8) Input=:
ADAT
• INPUT:
* Make the sampling rates of the ADAT and the VSR-880 the same.
O To record from the VSR-880 to the ADAT
1. Set the track status of the VSR-880 to PLAY.
2. Set the track status of the ADAT to REC.
3. Play back the VSR-880.
4. When the ADAT locks and the [PLAY] light stop flashing and turns solid, press [RECORD] while holding [PLAY] on the
ADAT.
5. To stop recording, press [STOP] on the VSR-880.
O To record from the ADAT to the VSR-880
1. Set the track status of the VSR-880 to REC.
2. Set the status of all tracks on the ADAT to PLAY.
3. Set the input channels of the recording tracks to ON.
[SHIFT]+[TR MIX (EXT SYNC)]
Switch tracks with [SHIFT]+STATUS [1] to [8]. TR1 Assign IN1=On, TR2 Assign IN1=On, ...
4. Press [REC] and [PLAY] on the VSR-880.
5. To stop recording, press [STOP] on the VSR-880.
It takes about 10 seconds after the VSR-880 starts playing until the ADAT locks and recording and playback in
synchronization are possible. Start the VSR-880 song at least 15 seconds earlier than the actual point you want to start
recording/playback.
24
VSR-880
Sampling Clock
Control Signal
Time Code
"SYS System PRM?"
INT [ENT/YES]
"SYS MIDI PRM?" [ENT/YES]
MASTER
"SYS Sync/Tempo PRM?"
EXT
R-BUS
(PARAMETER [ ][
On
(PARAMETER [
R-BUS
DIGITAL
(PARAMETER [
R-BUS
S
C
T
[ENT/YES] (PARAMETER [
(PARAMETER [
[ENT/YES] (PARAMETER [
])
][ ]) "Input="
* If any is set to REC, ADAT starts recording.
][ ]) "Assign"
DIF-AT
SYNC
S
C
POWER
OUT
IN
OPTICAL
IN
OUT
T
SYNC IN
adat
][ ])
][ ])
][ ])
[SHIFT]+STATUS [1] to [8]