Connecting A Tascam Da Series Recorder To The Vm-3100Pro - Roland VM-7100 Connection Manual

(14) Connecting a TASCAM DA series recorder to the VM-3100Pro

• Transferring audio via digital connection between TASCAM DA series and the VM-3100Pro.
• The TASCAM DA series can be controlled with the VM-3100Pro's transport buttons such as play and stop.
* TASCAM DA series: DA-98/88
Connection
fig.14
S
C
T
Equipment required
VM-3100Pro, DIF-AT, TASCAM DA-98/88, TDIF Cable (PW-88D), SYNC Cable (PW-88S)
Turning on the system
Connect the equipment and then turn the power on in the following order.
TASCAM DA series VM-3100Pro
Settings
VM-3100Pro
DIF-AT PREF
• ClockSel:
• AudioSel:
• TC Master:
To transfer the time code from the DIF-AT to the VM-3100Pro, and output as MTC (MIDI time code) from MIDI OUT
on the VM-3100Pro
• ThruToMTC:
SYSTEM PREF page
• MasterClk:
• LocatorType:
• RecorderType:
SYSTEM MIDI page
• TimingMon:
• Transport:
EZR OUT page
Transmitting the output from channels 1-8 directly to R-BUS 1-8
• Tr1/2=:
• Tr3/4=:
• Tr5/6=:
• Tr7/8=:
The track status on the TASCAM DA series can be changed with the VM-3100Pro.
REC TRACK SEL page [LEVEL METER]
TASCAM DA-98/88
• CLOCK:
• DIGITAL IN:
The VM-3100Pro works with only a 44.1kHz sampling rate. So the tape for TASCAM DA series should be formatted for
44.1kHz.
20
VM-3100Pro
Sampling Clock
Control Signal
Time Code
[LEVEL METER] [F1-F4 ON/OFF]
DA-88
DA-88
DA-88
ON
[SYSTEM]
RMDB-2
TIMECODE
TAPE
[SYSTEM] [F1-F4 ON/OFF]
TIMECODE
RECORDER
[EZ ROUTING] [F1-F4 ON/OFF]
CH01/02
CH03/04
CH05/06
CH07/08
INT
ON
R-BUS
S
C
T
TASCAM DA series
[F3](MTR)
[F2](MIDI)
[F2](OUT) (CURSOR
[F1-F4 ON/OFF] [F3](MTR)
DIF-AT
SYNC
C
POWER
TDIF
S
T
SYNC IN
[F1-F4 ON/OFF] [F4](PREF)
)
[SELECT] 1-8