en Home Connect
Notes
¡ Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the Home Con-
nect app.
→ "Safety", Page 2
¡ Hobs are not designed to be left unattended. Al-
ways monitor the cooking process.
¡ Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the Home Connect
app.
¡ In networked standby mode, the appliance requires
a maximum of 2 W.
22.1 Setting up Home Connect
Requirements
¡ The appliance is connected to the power supply and
is switched on.
¡ You have a mobile device with a current version of
the iOS or Android operating system, e.g. a smart-
phone.
¡ The mobile device and the appliance are within
range of your home network's Wi-Fi signal.
22.2 Overview of the Home Connect settings
You can adjust the settings and network settings for Home Connect by going to your hob's basic settings.
Setting
Selection or display
Network connection
– Not connected/disconnect network
– Connect automatically
– Connect manually
– Connected
Connection to app
– Not connected
– Connect
Connection to the Wi-Fi
– Wireless module switched off
– Wireless module switched on
Set using the app
– Switched off
– Switched on
Software update
– Update available and ready to in-
stall
– Start installation
Controlling remote access by after-
sales service
– Not authorised
– Authorised
1
Factory setting
18
1
1.
Download the Home Connect app.
2.
Open the Home Connect app and scan the follow-
ing QR code.
3.
Follow the instructions in the Home Connect app.
Additional information
Log on the hob in the Wi-Fi home network (Wi-Fi) or dis-
connect from the network
is only displayed if the hob is connected to the
home network.
If Wi-Fi has been activated, you can use the Home Con-
nect functions.
is only displayed if the hob has been previously
connected to a network.
If is switched off, only the hob's operating statuses
are displayed in the Home Connect app.
is only displayed if a software update is available.
is only displayed if after-sales service is attempting
to connect to the hob. After granting access, you can ter-
minate this at any time.