Table of Contents
Advertisement
BEFORE OPERATION
Press the POWER switch on the rear panel to turn on the
power.
After the POWER indicator's color has changed from orange to
green, press the OPEN button to release the printing unit out.
Remove the paper strip bin and then pull the knob to open the
door.
Install the print paper into the unit.
Place the printing paper in the correct orientation.
Make sure the paper roll is firmly installed.
Do not push down on the printing unit or the door.
If you push down on the printing unit or the door when they are open, this unit may
fall and it can cause damage or injury.
Load the paper roll slowly into the unit. If it is dropped along the ditches, the unit or
accessories may be damaged.
Remove the sticker, insert the print paper between the roller
and guide as shown right, and feed the print paper until the
buzzer sounds.
Remove the sticker before inserting the print paper between roller and guide. Make
sure to insert the paper straight.
Buzzer continues to sound until the printing unit is closed.
•
Keep the rollers clean. Dirt on the rollers may produce poor print quality.
•
When taking the print paper out, pull it up toward you by holding the paper
flanges.
•
Make sure to turn on the power before replacing the print paper.
•
Make sure to eliminate any slack from the print paper. If you carry out the
following steps without eliminating the slack, the print paper may be damaged.
Close the door.
All manuals and user guides at all-guides.com
CAUTION
NOTE
NOTE
NOTE
POWER switch
OPEN button
Direction of paper insertion
Roller
Guide
Knob
Print paper
Roller
12
Advertisement
Table of Contents
