Advertisement
Advertisement
Table of Contents
Summary of Contents for VADA FLOW BOSS VFB-DSU-WM
- Page 1 Scan for set up support Quick Start Guide Vada Flow Boss Wall Mount Accessory Kit VFB-DSU-WM...
- Page 2 THANK YOU INSTALLATION Thank you purchasing a Vada Flow Boss Wall Mount Accessory Kit! Let’s get started! 4. Connect the wiring as indicated below. Follow the steps opposite to set it up quick smart. 1. Remove all items from packaging.
- Page 3 10. Place the wall mount on a solid flat surface. Using the screws provided drill into the surface. 8. Screw the ends in. 11. Mount the digital switch. 9. Tighten the screw ends. Congratulations, your Vada Flow Boss Digital Water Switching Unit is now securely mounted.
Need help?
Do you have a question about the FLOW BOSS VFB-DSU-WM and is the answer not in the manual?
Questions and answers
I have installed a new switching unit on existing pump and it tells me on display no water to pump so won’t turn on automatically when I push reset it turns on when tap is open . Then when I shut tap off and then turn it back on it won’t start up and tells me no water to pump ca you please help thanks
The VADA FLOW BOSS VFB-DSU-WM may display "no water to pump" after installing a new switching unit if the wiring is not connected correctly during installation. Ensure the wiring follows the instructions and that all connections are secure. Also, check that the unit is properly mounted and all screws are tightened.
This answer is automatically generated