Table of Contents
Advertisement
INSTALLATION
7. Tighten the central mechanism.
8. Screw the ends in.
9. Tighten the screw ends.
1
2
10. Place the wall mount on a solid flat
surface. Using the screws provided drill
into the surface.
11. Mount the digital switch.
Congratulations, your Vada Flow
Boss Digital Water Switching Unit
is now securely mounted.
Advertisement
Table of Contents
Need help?
Do you have a question about the FLOW BOSS VFB-DSU-WM and is the answer not in the manual?
Questions and answers
I have installed a new switching unit on existing pump and it tells me on display no water to pump so won’t turn on automatically when I push reset it turns on when tap is open . Then when I shut tap off and then turn it back on it won’t start up and tells me no water to pump ca you please help thanks
The VADA FLOW BOSS VFB-DSU-WM may display "no water to pump" after installing a new switching unit if the wiring is not connected correctly during installation. Ensure the wiring follows the instructions and that all connections are secure. Also, check that the unit is properly mounted and all screws are tightened.
This answer is automatically generated