Getting Started; Maintenance; Operation - Hoover POWERSCRUB XL User Manual

GETTING STARTED

ASSEMBLY
Assemble the product completely before using it.
1
Insert the handle into the base.
2
Align the groove on the backside of the clean water
tank with the handle and drop straight down.

OPERATION

CAUTION:
Do not use this EXTRACTOR
on hard floors. Using this PRODUCT on hard
floors may scratch or damage your floor.
WARNING:
To reduce the risk of
personal injury, unplug before cleaning or
servicing.
FILL THE CLEAN WATER TANK
1
Lift up to remove the Clean Water Tank, then
remove the cap and add warm water or your
preferred cleaning solution according to the
SDS guidelines for your solution, fill to the line.
Secure cap.
2
Align the tank and firmly press it into place.
NOTE: Test for colorfastness in a small, hidden
area. Gently rub surface with a dampened white
cloth. Wait ten minutes and check for color
removal or bleed with a white paper towel.
NOTE: For the best results, vacuum carpet and
upholstery thoroughly with a Hoover Commercial
vacuum before use.
HOW TO USE
1
Plug the cord into an electrical outlet.
Recline
On/Off
2
Turn unit ON/OFF with side pedal.
3
Recline unit with the middle pedal.
4
Squeeze trigger to apply water and cleaning
solution.
5
Slowly push forward with trigger pressed to
wash, then slowly pull backwards with trigger
released to dry.
NOTE: For Best Results, rinse the carpet after
deep cleaning with clean water only. This will
remove residual carpet cleaning solution from
your carpets.
EMPTY THE RECOVERY TANK
NOTE: To maintain proper suction, empty Tank
when Red Bobber is visible.
1
Turn the cleaner off and unplug from electrical
outlet.
2
Grab the Recovery Water Tank handle and lift
up and outward to remove it. A second handle
is provided on the back of the Recovery tank for
carrying the tank.
3
Unlatch the tank lid and empty it. Rinse and allow
to air dry.

MAINTENANCE

WARNING:
To reduce the risk of
personal injury, unplug before cleaning or
servicing.
IMPORTANT: To prevent possible leaking, remove
Clean Water Tank and Dirty Water Tank.
If appliance is not working as it should, has been
dropped, damaged, left outdoors, or dropped into
water, call customer service at 1-888-768-2014
prior to continuing use.
LUBRICATION: The motor is equipped with
bearings which contain sufficient lubrication for
their lifetime. The addition of lubricant could
cause damage. Do not add lubricant to motor
bearings.
CORD STORAGE: Wrap the power cord around
the cord hooks for convenient storage. Attach
the plug end to the cord.
NOZZLE CARE
1
First turn off and unplug the carpet cleaner.
Remove Recovery Tank.
2
Pull up on the Nozzle slightly to unsnap, then
pull the Nozzle forward to remove it from carpet
cleaner. Rinse with water and allow to air dry.
3
To replace it, position Nozzle onto the front end
while making sure to align the tabs at the bottom
of the Nozzle with the notches on the foot.
4
Snap Nozzle to foot and rotate the latch into the
lock position.
IMPORTANT: The nozzle must be in the proper
position for the Dirty Water Tank to go on properly
and for the unit to have proper suction.
BRUSH CARE
1
Push the latches out on the side of the foot until
they lock open.
2
The Brush assembly should be free to pull out.
3
Rinse the brushes under running water.
4
Replace them by aligning the center drive post
and note the arrows indicating the front of the
machine. Push firmly until the latches lock into
place.