Table of Contents
Advertisement
Chapter 3 BIOS Setup
3.11 Set Supervisor / User Password
The SUPERVISOR/USER PASSWORD utility sets the password.
disabled. If you want to change the password, you must first enter the current password, and then at the
prompt -- enter your new password. The password is case sensitive, and can be up to 8 alphanumeric
characters. Press <Enter> after you have finished typing in the password. At the next prompt, confirm the
new password by re-typing it and pressing <Enter> again. When you are done, the screen automatically
reverts to the main screen. Remember that when you use this feature, the Security Option line in BIOS
FEATURES SETUP will determine when entering the password will be required.
Standard CMOS Features
Advanced BIOS Features
Advanced Chipset Features
Integrated Peripherals
Power Management
PnP / PCI Configure
ESC: Quit
F10: Save & Exit Setup
To disable the password, press the <Enter> key instead of entering a new password when the Enter
Password in the dialog box appears. A message will appear confirming that the password is disabled.
If you have set both supervisor and user password, only the supervisor password allows you to enter the BIOS
SETUP PROGRAM.
Note:
If you forget your password, the only way to solve this problem is to discharge the CMOS memory.
42
Phoenix - Award BIOS CMOS Setup Utility
Enter Password:
Change/Set/Disable Password
The SBC is shipped with the password
PC Health Status
Load Optimized Defaults
Set Supervisor Password
Set User Password
setup
Saving
: Select Item
User's Manual
Advertisement
Table of Contents
