Table of Contents
Advertisement
Changeover switch
The slide switch above the On/Off switch is for setting the direction of rotation of the
cordless screwdriver and for preventing the cordless screwdriver from being switched on
inadvertently.
You can select between clockwise and counter clockwise rotation. To avoid causing
damage to the gearing, the direction of rotation must only be changed when the screw-
driver is at a standstill.
When the slide switch is in the middle position, the On/Off switch is blocked.
On/Off switch
Infinitely variable speed control is possible with the On/ Off switch. The further you push the
switch, the higher the speed of the cordless screwdriver.
Changing the bit
CAUTION!
Set the changeover switch to its center position whenever you carry out any work (for
example changing the tool, maintenance work, etc.) on the cordless screwdriver.
Open the chuck
-
The chuck opening must be large enough to hold the tool (drill bit or screwdriver bit
-
Select the suitable tool. Push the tool as far as possible into the chuck opening
-
Tighten the chuck and then check that the tool is se- cure
-
Screwing
It is advisable to use self-centring screws (e.g. Torx, cross recessed head) as these will
enable you to work safely and reliably. Always make sure that the bit used is of the same
size and shape as the screw. Set the torque to suit the screw size as specified in the
instructions.
CLEANING AND MAINTENANCE
Always pull out the mains power plug before starting any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as
-
possible. Wipe the equipment with a clean cloth or blow it with compressed air at low
pressure
We recommend that you clean the device immediately each time you have finished
-
using it
Clean the equipment regularly with a moist cloth and some soft soap. Do not use
-
cleaning agents or solvents; these could attack the plastic parts of the equipment.
Ensure that no water can seep into the device. The ingress of water into an electric tool
in- creases the risk of an electric shock
Maintenance
There are no parts inside the equipment which require additional maintenance.
Advertisement
Table of Contents
