Table of Contents
Advertisement
Available languages
Available languages
5.3
FILLING THE MINCER (see fig 7)
When using the mincer, it is important that you stand in the correct position. Do not position yourself
so that any part of your body comes in direct contact with the mincer when working.
N.B The mincer must be filled when working. The procedure to follow is:
1. Place the food in the tray (1);
2. Start the mincer using the start button.
3. Raise the pestle (2);
feed the meat into the tube (3);
Without forcing use the pestle to push the meat into the opening.
4. If the meat suitably cut beforehand there should be no problems
with the screw feeder, however, if there are problems tighten
the lock nut until the meat is cut to desired size.
5. So, both the disk and blade last longer and to maintain their sharpness in time:
- When all the meat has been minced turn off the appliance.
- Blade and disk must always be coupled.
6. Do not tighten the lock nut excessively.
7. Press the stop button when you have finished using the appliance, then strip the appliance and
thoroughly clean both the opening and all other components.
6
REGULAR CLEANING
6.1
GENERALITIES
-
The appliance clean must be cleaned at least once a day or if necessary, more than once.
-
Scrupulously clean all the various components of the TRH12/TRH22 whether they come in
direct contact with the food product or not.
-
Never clean the TRH12/TRH22 with a pressurized waterjet, industrial cleaner, and brushes or
any other type of cleaning utensil that could damage the surface of the appliance.
-
Before cleaning you must remove the electricity supply plug isolating the appliance from the
main power circuit.
6.2
PROCEDURE TO FOLLOW FOR CLEANING THE APPLIANCE
-
remove the pestle and food tray.
-
unscrew the lock nut: No.1 and remove the disk: No.2, blade No. 3, screw feeder No.4,
unscrew in the direction indicated by the arrow No.5.
-
unscrew the knob and remove the mincer No.6, always in the direction indicated by the arrow.
Now all the components can be washed (see fig 6 ) using warm water ( 50 °c) and a neutral
detergent. To clean the main structure, use a damp cloth remember to frequently rinse.
The grater roller mounted on the TRH12/TRH22 Should be brushed. Carefully clean the punched
holes. Make sure all the components are completely dry before remounting them.
FIG 6 removing components.
N.B. to remount the TRH12/TRH22 follows the above diagrams:
1)
Mount the mincer block and block it in position using the knob; the pin on the knob must be
inserted into the opening No.7.
2)
Insert the screw feeders No.4 into the mincer block make sure it is positioned correctly.
3)
Mount the blade No.3 onto the square pin on the screw feeder and then mount the disk No.2
16
Advertisement
Table of Contents
