Table of Contents
Advertisement
Chapter 1. Playing Back Songs
■ Adding Harmonies to the Mic Vocals (Harmony)
You can sing with a harmony accompaniment, even when you're playing solo. This
is called the "Harmony" function.
1.
Press the [Function] (Exit) button so the indicator is lit.
2.
Press the [Song] (Select -) button or [
the VOCAL screen.
fig.
3.
Press the [Song] (Select -) button or [
value for "Harmony" to flash.
fig.
4.
Press the [
harmony settings.
Value
Unison
Oct Up
(Octave Up)
OctDwn
(Octave Down)
5th Up
3rd Up
4thDwn
(4th Down)
Data
Off
5.
Press the [Function] (Exit) button so the indicator goes out.
40
] (Value -) button or [
Sounds like two people singing the same melody.
Adds another voice one octave higher than the original.
Adds another voice one octave lower than the original.
Adds harmony a fifth above the original.
Adds harmony a third above the original.
Adds harmony a fourth below the original.
As you sing along with the playback of the song data, har-
monies consistent with the scale of the specified part are
added.
Set the part to which harmonies are added in "Setting the
Part to Which Harmonies Are Added (Harmony Part)" (p.
101).
No harmonies are added to the microphone vocals.
] (Select +) button to display
] (Select +) button to get the
] (Value +) button to change the
Description
You can change the settings for
the Harmony function with the
remote control's [HARMONY]
button (p. 34).
NOTE
Depending on the type of
harmony, harmonies cannot be
added to some songs on the
included CD.
Advertisement
Table of Contents
