Table of Contents
Advertisement
60
Setup-Program
Embroidery hoop adjustment
Service Screen
· service screen appears
· select screen
· select this screen if the on-screen
buttons do not react properly when
selected (touched)
Calibration
· screen calibration screen appears
· press each black point in the center,
one after the other
· it is not important which point is
selected first
· the machine will beep when the
dots are touched to let you know
contact was made
· will automatically go back to the
previous screen
· touch esc to return to the setup
screen
This adjustment calibrates the
needle to the center of the embroi-
dery hoop and is only needed the
first time the embroidery module
Setup menu
· press the external Setup button
· menu appears
· touch service
Service Screen
· service screen appears
· select Adjustment of hoop
Hoop adjustment
· hoop adjustment screen appears
· connect the embroidery module to
the machine
· attach the large hoop to the
embroidery module
· insert the embroidery template into
the hoop
030787.52.04_Nähen_04-01_a165 a170 a180_EN
· touch esc to return to last selected
stitch screen
Important Note: When calibrating
the screen, take care to touch the
black dots only. If the screen is
miscalibrated by touching any area
other than the black dots, it may
require a technical adjustment by
an authorized technician.
(special accessory) is being used. The
hoop adjustment can only be activa-
ted if the Embroidery Module is
attached
· touch check – the machine reads
the hoop position; the needle
should be positioned exactly over
the center point of the template
· if it is not, adjust with the arrows
· it is only necessary to adjust the
hoop once – the same setting
changes will apply to all the hoops
Advertisement
Table of Contents
