Advertisement
Quick Links
PARTS
A
Connector Part*
*Number of Parts Varies per Order
1
Fully assemble purchased Labyrinth pieces according to their included
assembly instructions.
Take one of your assembled Labryinth pieces and ip it upside-down. The
2
groove on the bottom should be facing up.
LABYRINTH CONNECTORS
ASSEMBLY GUIDE
B
Screw*
PIKLER
REQUIRED
Phillips
Screwdriver
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Sprout PIKLER LABYRINTH CONNECTORS
Summary of Contents for Sprout PIKLER LABYRINTH CONNECTORS
- Page 1 PIKLER LABYRINTH CONNECTORS ASSEMBLY GUIDE PARTS REQUIRED Phillips Screwdriver Connector Part* Screw* *Number of Parts Varies per Order Fully assemble purchased Labyrinth pieces according to their included assembly instructions. Take one of your assembled Labryinth pieces and ip it upside-down. The groove on the bottom should be facing up.
- Page 2 Press Connector Part A into one of the grooves. Make sure that the side with the hole is the side pressed into the groove, as shown below. Insert Screw B through hole, as shown below. Use screwdriver to thread screw into insert until ush. Repeat Steps 3-4 with additional Connector Parts A as needed.
- Page 3 Take other assembled Labyrinth piece and place it on Connector Part A , aligning the groove on the bottom with the installed Connector. Gently apply pressure to second assembled Labyrinth piece to press down onto Connector Piece A until fully seated and ush with the oor. Repeat Steps 2-7 for any additional assembled Labyrinth pieces that you would like to connect.
- Page 4 WWW.SPROUT-KIDS.COM QUARK ENTERPRISES 2022 PO BOX 1123, PROVO, UT 84601 DOCUMENT: AI-PIK-LAB_BRAK...
Need help?
Do you have a question about the PIKLER LABYRINTH CONNECTORS and is the answer not in the manual?
Questions and answers