GE GSD6000 Owner's Manual page 5

Extras
2
The light above the selected pad will be ON to indicate which EXTRA has been selected.
HEATED DRY Shuts off the drying heat option. Dishes air dry naturally and energy is saved.
Light OFF For faster air dry, you can prop the door open after the CLEAN light illuminates.
HEATED DRY Turns the heater on for fast drying. This will extend the time to your wash cycle
Light ON by 8 minutes for the SPEED CYCLE and 30 minutes for all other cycles.
NOTE: Cannot be selected with RINSE ONLY cycle.
LOCK You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you have started a cycle.
Children cannot accidentally start dishwasher by touching pads with this
option selected.
To unlock the dishwasher controls, press and hold the HEATED DRY pad for 3 seconds.
To lock the dishwasher, press and hold the HEATED DRY pad for 3 seconds. The light
above the LOCK pad will turn off.
EXTRA When selected, the cycle will run longer with heating elements on to improve both
HOT WASH wash and dry performance. NOTE: Cannot be selected with RINSE ONLY cycle.
DELAY HOURS You can delay the start of a wash cycle for up to 8 hours (on some models). Press the
DELAY HOURS pad to choose the number of hours you want to delay the start of the
cycle, then press START/RESET. The machine will count down and start automatically
at the correct time. Pressing START/RESET a second time will cancel the
DELAY START selection. NOTE: If you forget to fully close the door, a reminder signal
will beep until you do so.
RESET To change a cycle after washing starts, touch the START/RESET pad to cancel the cycle.
The START/RESET light will flash while the water is pumped out if needed. This takes
approximately 90 seconds. When the light stops flashing, the dishwasher can be
reprogrammed and restarted.
Start
3
Close the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET
pad to begin the cycle. Water fill begins, and approximately 60 seconds later the wash action begins.
NOTE: The dishwasher remembers your last cycle so you don't have to reprogram each time. When
the dishwasher door is fully closed, the control panel lights will display the last settings you selected.
If you don't want to change any of the settings, simply touch the START/RESET pad to begin the cycle.
If the door is closed the indicator lights will turn off if the START/RESET pad is not selected within
two minutes. To activate the display, open and close the door or press any pad.
Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed.
Make any new selections and touch the START/RESET pad to begin the cycle.
Clean
4
The CLEAN light is illuminated when a wash cycle is complete. The light will stay ON until the
door is opened.
www.GEAppliances.com
5