Table of Contents
Advertisement
Operating the Traction
Drive
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust
it properly, if necessary; refer to
and Adjusting the Traction Cable (page 25)
more information.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 25)
to an Authorized Service Dealer for service.
1.
To engage the traction drive, squeeze the left
(traction) lever to the handgrip
Figure 20
2.
To stop the traction drive, release the traction
lever.
Checking
Checking and Adjusting
or take the machine
(Figure
20).
Operating the Speed
Selector
The speed selector has 6 forward and 2 reverse
gears. To change speeds, release the traction lever
and shift the speed-selector lever to the desired
position
(Figure
each speed selection.
for
g001011
19
21). The lever locks in a notch at
Figure 21
g322971
Advertisement
Table of Contents
