Safety Instructions; Intended Use - Centronic SensorControl SC711 Assembly And Operating Instructions Manual

General information
• Please keep the instruction manual safe!
• Only use unmodified original parts from the control unit manufacturer.
• Keep children away from control units.
• Observe all pertinent country-specific regulations.
Caution
• Risk of injury due to electric shock.
•
Connections to the 230 V mains must always be per-
formed by an authorised specialist.
•
Disconnect the connecting cable from the power prior to
installation.
• Keep people out of the system's range of travel.
•
If the system is controlled by one or more transmitters,
the system's range of travel must always be visible during
operation.
•
When connecting the control cables (protected extra-low
voltages), only use cables with sufficient electrical
strength.
• Observe the specifications for the sun protection system.
The sensor described in this instruction manual must only be used for operat-
ing Centronic-compatible radio drives and radio control units. The sensor is in-
tended solely for the operation of sun protection systems. Use for other pur-
poses or for purposes beyond the above constitutes improper use.
• Please note that radio-controlled systems may not be used in areas with
a high risk of interference (e.g. hospitals, airports).
• The remote control is intended solely for use with equipment and sys-
tems in which malfunctions in the transmitter or receiver would not pose
any risk to persons, animals or property, or which contain safety devices
to eliminate such risks.
• The operator is not protected from interference from other telecommu-
nications systems and terminal equipment (e.g. even from radio-con-
trolled systems which are properly operated in the same frequency
range).
• Only connect radio receivers to devices and systems approved by the
manufacturer.
14 - en

Safety instructions

Intended use