Table of Contents
Advertisement
8
General Information
This gas grill is certified for outdoor use and should be installed to conform with
codes. Check gas type and specifications located on the rating plate located on the back panel of the grill.
Natural Gas Hook-Up
The installation must be performed by a licensed gas fitter in accordance with AS/NZS 5601, and all
connections must be leak tested before operating the grill.
This natural gas grill is supplied with a 3000 mm supply hose with an inside diameter of 12 mm, complete
with bayonet fittings, designed for natural gas, and certified for outdoor use.
Attach the flex connector from the manifold assembly to the natural gas regulator supplied. Tighten using
two wrenches. (Do not use thread sealer/pipe dope.)
Note: The gas grill is designed to operate at a test point pressure of 1.00 kPA and must be checked after
installation by turning all burners on and measuring at the regulator outlet test point provided.
!
WARNING!
•
Do not route hose underneath drip pan.
•
Do not route hose over top of back panel.
•
Ensure all hose connections are tightened using two wrenches. Do not use teflon tape or pipe
dope on any hose connection.
•
Ensure the hose does not contact any high temperature surfaces, or it may melt and leak causing a
fire.
•
Do not use enclosure to store excess hose, as there is a greater chance of the hose contacting a hot
surface, it may melt and leak causing a fire.
•
Leak test all the connections using a soap and water solution, as per the leak testing instructions
found in this manual.
A restraining tether of adequate strength shall be fixed to the appliance and be suitable to be fixed to
the wall with 50 mm of each connection point. The length of the tether shall not exceed 80% of the
length of the hose assembly.
This unit includes an internal regulator which stabilizes the gas
pressure and improves grill performance. This regulator cannot
be adjusted. There is a pressure tap located on the side of the
regulator. It can be used by a qualified service person when
servicing the grill to determine if the regulator is functioning
properly. The screw within the pressure tap must always be
kept tight, except when performing a pressure test on the
regulator (qualified service personnel only).
www.napoleon.com
AS/NZS 5601 and
local
N415-0705-AU Sep 10.21
Advertisement
Table of Contents
