Fujitsu AGU12RLF Service Instruction page 64

1-5. Setting the Auto restart
Enable or disable automatic restart after a power interruption.
Setting Description
Enable
Disable
* Auto restart is an emergency function such as for power outage etc.
Do not attempt to use this function in normal operation.
Be sure to operate the unit by remote controller or external input device.
1-6. Setting the Room temperature sensor switching
(Only for Wired remote controller)
When using the Wired remote controller temperture sensor, change the setting to "Both" (01).
Setting Description
Indoor unit
Both
* 00 : Sensor on the indoor unit is active.
* 01 : Sensors on both indoor unit and wired remote controller is active.
1-7. Setting the Remote controller signal code
(Only for wireless remote controller)
The indoor unit signal code can be changed. Select the appropriate signal code.
Setting Description
A
B
C
D
1-8. Setting the External input control
"Operation/Stop" mode or "Forced stop" mode can be selected.
Setting Description
Operation /Stop mode
(Setting prohibited)
Forced stop mode
1-9. Setting the Indoor unit fan control for energy saving for cooling
Enables or disables the power-saving function by controlling the indoor unit fan rotation
when the outdoor unit is stopped during cooling operation.
Setting Description
Disable
Enable
* If setting value is "00" :
When the outdoor unit is stopped, the indoor unit fan operates continuously
following the setting on the remote controller.
* If setting value is "01" :
When the outdoor unit is stopped, the indoor unit fan operates intermittently at a very low speed.
(
Function Number
40
( Factory setting)
Function Number
42
( Factory setting)
Function Number Setting Value
44
( Factory setting)
Function Number Setting Value
46
(
Function Number Setting Value
49
03-02
Factory setting)
Setting Value
00
01
Setting Value
00
01
00
01
02
03
00
01
02
Factory setting)
00
01