Product Overview; Operation; Before Operation; Before Operation Safety - Toro Power Max 824 OE Operator's Manual

Product Overview

1. Handgrip (2)
2. Auger/impeller lever
3. Speed-selector lever
4. Quick Stick™
discharge-chute control
5. Traction lever
6. Fuel-tank cap
7. Oil-fill tube/dipstick
8. Chute deflector
Figure 12
1. Primer
2. Ignition switch
3. Choke
4. Fuel-shutoff valve
Figure 11
9. Discharge chute
10. Scraper
11. Auger
12. Skid (2)
13. Electric-start button
14. Electric-start plug-in
15. Snow-cleanout tool
5. Throttle
6. Oil-drain plug
7. Recoil-start handle
1. Snow-cleanout tool (attached to the handle)

Operation

Note:
Determine the left and right sides of the
machine from the normal operating position.

Before Operation

Before Operation Safety

g018887
•
For electric-start models only: Use extension
cords and receptacles as specified in the manual.
Thoroughly inspect the electrical cord before
plugging it into a power source. If the cord is
damaged, do not use it. Replace the damaged
cord. Unplug the power cord whenever you are
not starting the machine.
•
Wear adequate winter garments whenever
you operate the machine. Wear substantial,
slip-resistant footwear that improves footing on
slippery surfaces. Avoid loose-fitting clothing that
can get caught in moving parts.
•
Always wear eye protection during operation or
while performing an adjustment or repair to protect
your eyes from foreign objects that the machine
may throw.
•
Thoroughly inspect the area where you will use the
machine, and remove all doormats, sleds, boards,
wires, and other foreign objects.
•
If a shield, safety device, or decal is damaged,
illegible, or missing, repair or replace it before
beginning operation. Also tighten any loose
fasteners.
g016500
9
Figure 13
g004217