Table of Contents
Advertisement
QUICK START GUIDE
USER GUIDE
General Installation
LEVELING INFORMATION
NOTICE
Because these units do not have leveling legs,
it is extremely important that they sit on a level
surface. If they are not level, the ice mold will not
fill evenly.
Use a level to
confirm the unit is
level. Level should
be placed along top
edge and side edge
as shown.
1
INSTALLATION
1.
Plug in the power/electrical cord.
2.
Gently push the unit into position. Be careful not to
entangle the cord or water line.
3.
Re-check the leveling, from front to back and side to
side. Make any necessary adjustments.
4.
Remove interior packing material and wipe out the
inside of the unit with a clean, water-dampened cloth.
General Installation
USER GUIDE
First Use
INSTALLATION
All U-Line controls are preset at the factory. Initial startup
1.
Plug in the power/electrical cord.
requires no adjustments.
2.
Gently push the unit into position. Be careful not to
entangle the cord or water line.
NOTICE
3.
Re-check the leveling, from front to back and side to
U-Line recommends allowing the unit to run
side. Make any necessary adjustments.
overnight before loading with product.
4.
Remove interior packing material and wipe out the
U-Line recommends discarding the ice produced
inside of the unit with a clean, water-dampened cloth.
during the first two or three hours of operation
to avoid possible dirt or scale that may dislodge
from the water line.
To turn the unit on or off:
Press the rocker switch located below the temperature
control dial in the center of the grille.
u-line.com
CONTROL DIAL
The control dial sets a single continuous temperature.
This set point temperature is a base setting used by the
controller to maintain the temperature zone in the unit.
The factory default MID setting, number 3 or 4 set point,
is approximately 38
gauge for further temperature adjustments.
10
First Use
F (3
C). The set point temperature is a
º
º
u-line.com
Advertisement
Table of Contents
