U-Line Combo Series Quick Start Manual & Regulatory

U-Line Combo Series Quick Start Manual & Regulatory

Hide thumbs Also See for Combo Series:

Advertisement

QUICK START GUIDE
Combo
Models
115 V / 60 Hz
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Combo Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for U-Line Combo Series

  • Page 1 QUICK START GUIDE Combo Models 115 V / 60 Hz ® •...
  • Page 2 1. U-Line Customer Care must be contacted immediately at +1.800.779.2547. 2. Service or repairs performed on the unit without prior written approval from U-Line is not permitted. If the unit has been altered or repaired in the field without prior written approval from U-Line, claims will not be eligible.
  • Page 3: Table Of Contents

    QUICK START GUIDE u-line.com This Quick Start Guide covers the basics of installation and general use of your product. For more details, see the complete User Guide & Service Manual on u-line.com. Contents Safety and Warning Environmental Requirements Electrical Water Hookup...
  • Page 4: Safety And Warning

    QUICK START GUIDE u-line.com Safety and Warning Environmental Requirements This model is intended for indoor/interior applications only NOTICE and is not to be used in installations that are open/ Please read all instructions before installing, exposed to natural elements. operating, or servicing the appliance.
  • Page 5: Electrical

    PREPARE PLUMBING WARNING The water valve uses a standard 1/4" (6.35 mm) compression fitting. U-Line recommends using accessory SHOCK HAZARD — Electrical Grounding water hook up kit – part # WATERHOOKUP. The kit Required. Never attempt to repair or perform...
  • Page 6 QUICK START GUIDE u-line.com 3. Locate water valve inlet. CAUTION Do not use any plastic water supply line. The line is under pressure at all times. Plastic may crack or rupture with age and cause damage to your home. Do not use tape or joint compound when attaching a braided flexible water supply line that includes a rubber gasket.
  • Page 7: Door Swing

    BI95/BI98 All units have a zero clearance for the door to open 90°. U-Line recommends a minimum door clearance of 1/4" (6 mm) to accommodate the handle if the unit is installed next to a wall.
  • Page 8: Door Adjustments

    QUICK START GUIDE u-line.com Door Adjustments DOOR ALIGNMENT AND ADJUSTMENT Align and adjust the door if it is not level or is not sealing properly. If the door is not sealed, the unit may not cool properly, or excessive frost may form in the interior.
  • Page 9 QUICK START GUIDE u-line.com 3. Remove door by tilting forward and lifting door off 3. Rotate gasket 180°, aligning notch with plunger bottom hinge. Retain shoulder washers; they will be bracket and pressing firmly into the gasket channel reused. starting at the corners.
  • Page 10: General Installation

    QUICK START GUIDE u-line.com General Installation 1. Use a level to confirm the unit is level. Level should MARINE AND BI95/BI98 SERIES be placed along top edge and side edge LEVELING INFORMATION as shown. NOTICE Because these units do not have leveling legs, it is extremely important that they sit on a level surface.
  • Page 11: Integrated Panel Installation

    QUICK START GUIDE u-line.com 3. Re-check the leveling, from front to back and side to 2. Pull door gasket out of groove side. Make any necessary adjustments. The unit’s top (top edge of door only). Start in surface should be approximately 1/8" (3 mm) below the middle and pull outward, the countertop.
  • Page 12 4. Upon removal, lay gasket Clamp using clamps. A down on a flat surface. robust tape may also be used. U-Line 5. Partially loosen the 3 screws, securing the top hinge to recommends the use the cabinet. of bar clamps to...
  • Page 13 QUICK START GUIDE u-line.com 13.Be sure the screws force their way past the opening on the gasket channel and sit flush against the bottom of the channel. Integrated Panel Integrated Panel 14.Remove clamps from door/drawer. If panel requires additional adjustment after removing clamps, slightly loosen each screw and adjust panel as necessary.
  • Page 14: Control Operation

    QUICK START GUIDE u-line.com Control Operation Up Down Light Power Used LED CONTROL FUNCTION GUIDE FUNCTION COMMAND DISPLAY/OPTIONS ON/OFF Press and release Unit will immediately turn ON or OFF. Press and release to leave interior Toggle lights Glass door wine and beverage centers only.
  • Page 15: First Use

    First Use To turn off ice production: Raise the bin arm into an upright and locked position. The unit will preserve All U-Line controls are preset at the factory. Initial startup temperature for ice storage. requires no adjustments. NOTICE NOTICE...
  • Page 16: Sabbath Mode

    5. Sabbath Mode remains active until (4) is quickly pressed and released. Ice production will remain suspended until the lever is placed back into its original (Lowered) position. Copyright © 2016/2017 U-Line Corporation. All Rights Reserved. Publication Number 30593 12/2018 Rev. D...
  • Page 17 One Year Limited Warranty For one year from the date of original purchase, this U-Line product warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or workmanship. For products installed and used for normal residential use, material cosmetic defects are included in this warranty, with coverage limited to 60 days from the date of original purchase.

Table of Contents