Ryobi P770ID Operator's Manual page 7

WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
REMOVING WASTE FROM THE COLLECTION
CONTAINER
See Figure 8 - 9, page 10.
The collection container should be checked, emptied, and
cleaned periodically to obtain maximum efficiency.
Dry waste:
 Remove the battery pack.
 Unlock the four locking latches and remove the lid.
 Remove the dry use filter.
 Inspect filter, lightly shake any dust or dirt from the filter,
or replace as necessary.
 Empty the collection container; wash out if necessary.
 Replace dry use filter.
 Before replacing the lid, make sure all pieces are
completely dry.
 Replace lid and lock securely.
Liquid waste:
 Remove the battery pack.
 Unlock the four locking latches and remove the lid.
 Empty the collection container; wash out if necessary.
Before replacing the lid, make sure all pieces are
completely dry.
 Replace lid and lock securely.
CAUTION:
Do not allow liquid pick up to remain in the collection
container for extended periods of time. Moisture can
develop in the motor compartment and shorten the life
of the motor.
Look for these accessories where you purchased this product or call 1-800-525-2579:
 Dry Use Filter .....................................................................................................................................................313052002
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER
MAINTENANCE
ACCESSORIES
FRENCH AND SPANISH LANGUAGE SECTIONS.
CAUTION:
Do not turn unit upside down, as liquid may enter the
motor unit.
REPLACING THE FILTER
See Figure 10, page 10.
 Remove the battery pack.
 Unlock the four locking latches and remove the lid.
To clean:
 Remove the dry use filter.
 Lightly shake any dust or dirt off the filter.
To replace:
 Remove the old filter.
 Replace with new filter.
NOTE: Make sure the filter is seated properly for dry
vacuuming. Remove the filter for wet vacuuming.
STORAGE
 Clean all foreign material from the wet/dry vac.
 Clean the outside of the collection container with warm
water and mild soap.
 Empty and clean the collection container, flexible hose,
wands, and attachments with warm water and mild soap
and allow to completely dry before storage.
 Store flexible hose and attachments inside the collection
container or on the lid.
 The collection container should be disinfected as needed
and before prolonged storage.
 Store indoors in a place that is inaccessible to children.
Keep away from corrosive agents such as garden
chemicals and de-icing salts.
7 — English