Table of Contents
Advertisement
Replacing the Lamp unit
J
CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the
z
lamp, the connector may be damaged.
Do not loosen other than designated screws.
z
1 )
Turn off the Power by following the procedure
in "Turning Off the Projector" (
disconnect the power plug from the power
outlet, and wait at least one hour, and then
check if the lamp unit has cooled down.
2 )
Use a Phillips screwdriver to loosen the lamp
cover fixing screw and remove the lamp
cover.
Remove the lamp cover by pulling it slowly toward the
z
direction of the arrow.
3 )
Use a Phillips screwdriver to loosen the
three lamp unit fixing screws until the
screws turn freely. Hold the used lamp
unit by its handles, and pull it gently from
the projector.
4 )
Insert the new lamp unit in correct
direction. Tighten the three lamp unit
fixing screws securely with a Phillips
screwdriver.
5 )
Attach the lamp cover, and tighten the
lamp cover fixing screw securely with a
Phillips screwdriver.
Attach the lamp cover by pushing it slowly opposite
z
the direction of the arrow.
Note
When you replace the new lamp unit (ET-LAV200), the projector resets the total usage time of the lamp unit automatically.
z
page 30),
Æ
Replacement
Lamp cover
Lamp cover fixing screw
Lamp unit fixing screws
Lamp unit
Lamp unit
ENGLISH -
81
Advertisement
Table of Contents
