Sony VPL-EX5 Operating Instructions Manual page 22

Projecting
1,2
1
Plug the AC power cord into a wall
outlet, and connect all equipment, then
remove the lens cover.
The ?/1 key lights in red and the
projector goes into standby mode.
2
Press the ?/1 key.
The ?/1 key lights after flashing in
green. (The projector cannot be used
while the ?/1 key is flashing.)
3
Turn on the equipment connected to
the projector.
22
Projecting
Rear remote
control detector
APA INPUT
KEY
STONE
ENTER
RESET MENU
PIC
MUTING
D ZOOM VOLUME
FREEZE
4
Press the INPUT key to select the
input source.
Each time you press the key, the input
signal switches as follows:
Input-A t Input-B t Video t S-Video
(VPL-EW5/EX50 only)
To input from
Computer/Component
connected to the INPUT
A connector
Computer connected to
the INPUT B connector
(VPL-EX50 only)
Computer/VCR, etc.
connected to INPUT B
(Digital) connector
(VPL-EW5 only)
Video equipment
connected to the VIDEO
input connector
Video equipment
connected to the
S VIDEO input
connector
Smart APA (Auto Pixel Alignment)
adjusts the picture of the connected
equipment so that it is projected clearly.
Notes
• If "Auto Input Search" is set to "On," the
projector searches for the signals from
the connected equipment and displays
the input channel where the input signals
are found.
For details, see "Auto Input Search"
on page 35.
• The Smart APA feature is effective for
the input analog signal from a computer
only.
5
Switch the equipment connected to
output to the projector.
Depending on the type of your
computer, for example a notebook, or an
all-in-one LCD type, you may have to
switch the computer to output to the
projector by pressing certain keys (e.g.,
Press INPUT
to display
Input-A
Input-B
Video
S-Video