Related Manuals for We 26110110240 0 Series
Summary of Contents for We 26110110240 0 Series
- Page 1 SER MANUAL VALUATION BOARD FOR RADIO MODULES HYONE -III(-SPI), S ROTEUS ETEBOS 26110110240 0, 2611011021000 ERSION 23, 2023...
- Page 2 This is especially important for Wireless Connectivity products that were not purchased directly from Würth Elektronik eiSos. A firmware update on these respective products may be required. We strongly recommend to include in the customer system design, the possibility for a firmware update of the product.
- Page 3 • LFXO crystal part number is updated in January chapter 3.5.5 . 2021 • Input capacitance variables respectively 3.5.5 . changed to • FCC exemption information is added in chapter 4 . Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 4 WIRELESS CONNECTIVITY & SENSORS Evaluation board user manual • Added footnote in "Supported radio modules" section, mentioning the laser marking modules. May 2023 • Added radiation characteristics in chapter 3.10 . • New corporate design. Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 5 SubMiniature version A Serial Wire Debug Universal Asynchronous Receiver Transmitter Universal Asynchronous UART allows communicating with the module of a specific Receiver Transmitter interface. Universal Serial Bus Voltage Drain Drain Supply voltage Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 6 Product life cycle ........32 Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 7 Miscellaneous ........37 Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 8 2611017221001 Thyone-I EV-Kit Long Range Table 1: Compatibility Figure 1: Product image Please be aware that the evaluation board can be delivered with a module containing a label or a laser marking. Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 9 Evaluation board with Thyone-I with SMA connection for external antenna 2.4GHz external antenna - 2600130021 USB2 A to USB Micro cable Packaging: ESD safe cover Table 4: Content Thyone-I EV-Kit Long Range Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 10 COM port name of the EV board. A typical name is "COM12" in Windows systems or "/dev/t- tyUSB0" in Linux systems. The WE-SmartCommander or any other serial terminal program (like hterm for Windows) has to be run and the corresponding COM port has to be opened using the default settings of the mounted radio module.
- Page 11 WIRELESS CONNECTIVITY & SENSORS Evaluation board user manual 3 Development board 3.1 Block diagram Figure 2: Block diagram Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 12 WIRELESS CONNECTIVITY & SENSORS Evaluation board user manual 3.2 Jumpers Figure 3: Jumpers, defaults Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 13 Table 7: Jumper JP3 JP3 description printed on the bottom of the evaluation board hardware ver- sion 2.0 is invalid. Jumper JP3 connections in the table 7 are updated and shall be used. Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 14 WIRELESS CONNECTIVITY & SENSORS Evaluation board user manual 3.3 Connectors and pin headers Figure 4: Connectors Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 15 CON3 Optional connection for NFC Antenna CON4 SMA connector for external antenna CON5 Optional connection for WE sensor EV-boards Edge card connector, see table 10 CON6 Table 8: Connector overview 3.3.1 CON1 Connector CON1 is a micro-USB connector that enables connection to PC via standard micro- USB cable.
- Page 16 22pF capacitor 885012005027 and C6 should be left unpopulated. 3.3.5 CON5 Connector CON5 is used to connect the WE Sensor evaluation boards. This feature is sub- jected to a customized firmware and not supported by default firmware.
- Page 17 B26, B28, B30, B32 SWCLK SWCLK SWDIO SWDIO P0.03 WAKE_UP P0.02 BOOT P0.12 P0.11 P0.18 RESET P0.23 RSVD P0.21 RSVD P0.07 RSVD P1.00 RSVD P1.08 UTXD P1.09 URXD P0.19 MODE_1 P0.22 BUSY Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 18 P0.23 RSVD P1.00 RSVD P0.07 RSVD P0.19 MODE_1 Table 12: Pinheader P2 nRF52840 Function P0.09 NFC1, RSVD P0.10 NFC2, RSVD P0.03 WAKE_UP P0.12 P0.11 P1.09 URXD P1.08 UTXD Table 13: Pinheader P3 Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 19 WIRELESS CONNECTIVITY & SENSORS Evaluation board user manual nRF52840 Function VDD 3V VDD 5 V Table 14: Pinheader P4 Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 20 WIRELESS CONNECTIVITY & SENSORS Evaluation board user manual 3.4 Buttons Figure 7: Buttons Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 21 JP2 (all even numbered pins). The module RXD line must be handled accordingly by your host (i.e. pulled up while inactive and during module boot-up). Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 22 9 + 10 10 = C, then whereas, 10 = = Load capacitance of LFXO crystal. = Input capacitance of Pad LED_1 (4 pF) = Input capacitance of Pad LED_2 (4 pF) Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 23 To apply this, remove the flash adapter connection. Make sure a jumper at JP6 is placed. Unplug and replug the USB connection of the device. Press the reset button on the evaluation board. Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 24 (2611017221001) is connected to the module In order to use the module’s onboard PCB antenna, the capacitor connection to SMA connector should be made according to the chapter 3.3.4 and figure 6 Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 25 WIRELESS CONNECTIVITY & SENSORS Evaluation board user manual 3.7 Schematic Figure 10: Schematic sheet-1 Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 26 WIRELESS CONNECTIVITY & SENSORS Evaluation board user manual Figure 11: Schematic sheet-2 Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 27 WIRELESS CONNECTIVITY & SENSORS Evaluation board user manual 3.8 Layout no metal antenna CON4 PCB edge Figure 12: Assembly diagram Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 28 WIRELESS CONNECTIVITY & SENSORS Evaluation board user manual Figure 13: Top,bottom & internal layers Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 29 EV Order code 2611017221001 (SMA Connection) CON1 Micro_USB Würth Elektronik 629105150521 CON2 2x10 Würth Elektronik 61002021121 CON3 BLLPSMD4S CON4 Würth Elektronik 60312102114405 CON5 Würth Elektronik 610106249221 CON6 not mounted DFLS130L-7 DFLS130L-7 LDO, 3V3 FT232RQ Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 30 (EV Kit dependant) not mounted not mounted 0402 not mounted not mounted 180R 0402 not mounted not mounted not mounted not mounted 430152043826 Würth Elektronik 430152043826 430152043826 Würth Elektronik 430152043826 not mounted Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 31 Radiaton characteristic shown is valid for the module on the evaluation board. It is important to be aware that size of groundplane and placement of module has infleunce on the radiation pattern Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 32 Equally, the national laws and restrictions may vary with the country. In case of doubt or uncer- tainty, we recommend that you consult with the authorities or official certification organizations of the relevant countries. Würth Elektronik eiSos is exempt from any responsibilities or liabili- ties related to regulatory compliance.
- Page 33 Necessary information is available on request. In this case, the field sales engineer or the internal sales person in charge should be contacted who will be happy to support in this matter. Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 34 As a standard reporting procedure of the Product Change Notification (PCN) according to the JEDEC-Standard, we inform about major changes. In case of further queries regarding the PCN, the field sales engineer, the internal sales person or the technical support team in charge should be contacted.
- Page 35 6.4 Usage restriction Würth Elektronik eiSos GmbH & Co. KG products have been designed and developed for us- age in general electronic equipment only. This product is not authorized for use in equipment Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 36 By using Würth Elektronik eiSos GmbH & Co. KG products, the customer agrees to these terms and conditions. Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 37 firmware are neither designed nor intended for use in areas such as military, aerospace, aviation, nuclear control, submarine, transportation (automotive control, train control, ship con- trol), transportation signal, disaster prevention, medical, public information network etc. You Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 38 USED. INFORMATION PUBLISHED BY WÜRTH ELEKTRONIK EISOS REGARDING THIRD- PARTY PRODUCTS OR SERVICES DOES NOT CONSTITUTE A LICENSE FROM WÜRTH ELEKTRONIK EISOS TO USE SUCH PRODUCTS OR SERVICES OR A WARRANTY OR ENDORSEMENT THEREOF. Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 39 We recommend you to be updated about the status of new firmware and software, which is available on our website or in our data sheet and manual, and to implement new software in your device where appropriate.
- Page 40 Configuration-II ........22 Thyone-I, Proteus-III(-SPI), Setebos-I Version 1.5, May 2023 www.we-online.com/wcs...
- Page 41 Contact Würth Elektronik eiSos GmbH & Co. KG Division Wireless Connectivity & Sensors Max-Eyth-Straße 1 74638 Waldenburg Germany Tel.: +49 651 99355-0 Fax.: +49 651 99355-69 www.we-online.com/wireless-connectivity...