Bloomy Lotus Sky - Aroma Diffuser Manual
![]()
Please read the user manual carefully before use.
Overview
![Bloomy Lotus - Sky - Overview Overview]()
- Glass outer cover
- Inner lid
- Water tank
- Mist spout
- Ventilation hole
- Water marker
- Mist chip
- Fan
- Air inlet
- LED light
- Mist button, time setting
- Light button, color setting
- Working hour indicator
- DC socket
- Power adapter
Operating Instructions
- Hold the base and remove the glass outer cover.
![]()
- Remove the Inner lid.
![]()
- Add water to the water tank below the RED Maximum water marker.
![]()
- Directly add 3-5 drops of natural essential oil into water tank.
![]()
- Replace the inner lid.
![]()
- Replace the glass outer cover. Ensure the glass cover and the base are aligned.
![]()
- Plug Power adapter into a power outlet.
![]()
- Press the Mist button to start the device and switch the timer.
![]()
- Diffuser will begin diffusing.
![]()
![]()
- Be sure to hold the whole product with the base carefully when moving the product. Handle this product with care to avoid impacts or drops.
- The unit should be placed on a level solid surface. Do not place on carpets, rugs, wooden/polished furniture or unstable surfaces.
- Use a suitable measuring cup to fill the water into the water tank. Never attempt to fill water under a running tap or whilst plugged in.
- The water level should not exceed the water marker to avoid damage to this device.
- Keep water away from Ventilation Hole and Air Inlet.
- For best result, we recommend that you use natural essential oil with this scent diffuser. Artificial fragrance, flavor, or impurities might harm to the unit.
- Always unplug the product from electrical socket when not in use.
- Do not remove the covers during operation.
Setting Instructions
- Press the button once to turn ON the unit. The default time is 2 hours, indicated by the "2H" green LED light.
- Press the button a second time and the working time is set to be 4 hours, indicated by the "4H" green LED light.
- Press the button for the third time and the working time is set to be 8 hours intermittently, indicated by the "8H" green LED light. (5 mins ON and 5 mins OFF).
- Press the button a fourth time to switch the diffuser OFF.
- The default rotating lights setting will start automatically while the device is in MIST mode.
- Press the Light button a first time to switch to "Light Blue"
- Press the Light button a second time to switch to "Candle Light".
- Press the Light button a third time to switch the "Purple Light".
- Press the Light button a fourth time to switch the light OFF.
![Bloomy Lotus - Sky - Light Button Light Button]()
Note:
- A slight difference in mist amount produced by different units is expected.
- Factors affecting the mist amount: water, humidity, temperature, and air flow.
- Automatically shut-off function when the diffuser detects the water is empty or when it is tipped over.
Cleaning and Maintenance
- Always disconnect the AC adaptor from the device before cleaning.
- Power off and disconnect the device from the power outlet.
![]()
- Hold the base and remove the glass outer cover.
![]()
- Remove the Inner lid.
- Make sure the air duct outlet is not subject to spilling. Pour water out from the opposite side (of the air duct outlet).
- Pour any remaining water down the drain.
![]()
- Use cotton swab and neutral detergent, then rinse thoroughly no less than twice a week.
![]()
- Never soak or wash this product directly as it may cause mechanical malfunction or danger.
- Never use acidic cleansing agents as it may cause malfunctions to the product.
- Use cotton swab to clean the unit after each use. Rinse with tap or spring water, then wipe with a dry cloth.
- The water tank must be cleaned before the essential oil is changed each time.
- Use tap water or spring water.
- Allow to dry thoroughly after use/ cleaning.
- Make sure no water will spit into the air duct outlet as it might break the electrical circuit.
Troubleshooting
If you experienced unsatisfactory operations, please follow our troubleshooting guidelines listed below.
Symptom | Possible Cause | Solution |
Diffuser does not turn on/diffuser shuts off before set time is over. | No water in the water tank Power cord not connected correctly | Add water to water tank until it reaches the RED Maximum water marker. Disconnect power cord and re-connect carefully. |
No mist or abnormal mist | Normal LED light but no mist. | - Check the water level. The water level should not be higher than the red water marker.
- Ensure that tap water or mineral water is added.
- Defective mist chip, please contact your direct retailer.
|
No mist when covered with lid. | - Avoid placing the product on soft or uneven surfaces. This will block the air inlet at the bottom.
- Determine if the fan is working. If it is not working, please contact your direct retailer.
|
Mist chip with oil residue. Air inlet at the bottom of the diffuser blocked? | Please follow instructions on cleaning and maintenance. Clean the air inlet. A partially blocked inlet may interfere with the level of mist output. |
Water Leak | Temperature and humidity levels can cause the mist to quickly condense into droplets. | Adjust room temperature and humidity levels to compensate. |
- Do not attempt to dismantle or repair the product by yourself. If the unit still does not operate satisfactorily, please contact your local distributor.
Product Dimensions
Product Name: SKY
Model code: BL-009
Product Size: Ø80mm(L) x 255mm(H)
Water: Room-temperature tap water/mineral water
Material: PP, Glass
Power input: DC24V / 12W
Manufacturer: Bloomy Lotus LLC
Main unit weight: 712g
Water Tank Capacity: 115ml
Coverage Area: Up to 45m2
Environment: Indoor
Run Time: 2 /4 /8 hours
Design: USA
Made in China
![]()
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Bloomy Lotus Sky - Aroma Diffuser Manual
Need help?
Do you have a question about the Sky and is the answer not in the manual?
Questions and answers