Advertisement
2 Remove the 2 screws that secure the side cover. Then remove the cover and place it to the side.
Important:
When you remove the case, you expose sensitive internal components. Avoid touching anything other
than the memory assembly when you remove or add memory.
3 Insert the new memory module in the slot:
a Align the notch on the gold edge of the module with the notch in the lower memory slot.
b Tilt the card and push the memory into the slot. Make sure the module is pushed in all the way.
c Use two fingers with firm, even pressure to push down on the memory module. You should hear a click
when the memory is inserted correctly.
Important:
Hold the memory module by its edges, and do not touch the gold connectors.
4 Replace the side case. Replace and tighten the 2 screws you removed in step 2.
Make Sure DiskStation Recognizes the New Memory Capacity
After installing the memory module on DiskStation, it's recommended that you check whether the server
recognizes the new memory.
To check DiskStation's memory:
1 Install DSM. (See the next chapter for more information.)
9 Chapter 2: Hardware Setup
Advertisement
