Advertisement
2 Log in to Synology DiskStation Manager.
3 Check
Total Physical Memory
If your DiskStation doesn't recognize the memory or doesn't start up correctly, confirm that the memory is
installed correctly.
Remove the RAM Module from DiskStation
1 Follow step 1 and 2 of the "Install the RAM Module" section to remove the case of DiskStation.
2 Push the levers on the sides of the memory module in an outward direction to release the module from the
memory card slot. Before removing it, make sure you see the half-circle notches. If you don't, try pushing the
levers outward again.
3 Hold the memory module by its notches and remove it from the slot.
4 Replace the side cover. Replace and tighten the 2 screws you removed in step 1.
10 Chapter 2: Hardware Setup
in
Main Menu
>
System
Information.
DS2411+
Advertisement
