Haier HSW79F18CIMM User Manual page 41

WARNING!
Do not adjust the hinge lifting shaft excessively to a height which might cause the
shaft to leave its original locked position .( Adjustable height range :3 mm )
2 h
Electrical connection
Before each connection check if:
▶ power supply, socket and fusing are appropriate to the rating plate.
▶ the power socket is earthed and no multi-plug or extension.
▶ the power plug and socket are strictly according.
Connect the plug to a properly installed household socket.
WARNING!
To avoid risks a damaged power cord must be replaced by the customer service
(see warranty card).
Removing and installing the doors
In the event that you need to remove the appliance doors , please follow the door
removal and installation instructions below .
WARNING!
▶ Before any operation , deactivate the appliance and disconnect the mains plug
from the mains socket .
▶ Block the water supply .
▶ The applance is heavy . Always handle with at least two persons .
▶ Do not tilt the appliance more than 45 or place it horizontally on the ground .
▶ The door may fall over and hurt people , or get damaged during these steps ,
please pay more attention when rermoving and instaling doors .
Installation
Waiting time
To the maintenance-free lubrication oil is
located in the capsule of the compressor.
This oil can get through the closed pipe
system during slanting transport. Before
connecting the appliance to the power
supply you have to wait at least 2 hours so
that the oil runs back into the capsule.
41