KP Electronic Systems ATSU100SD Programming Manual

ATSU100SD™
High-Power Long-Range
Radio Transmitter with
Built-in Dialer Interface
Programming Guide
Web Site: www.kpsystems.com
ISRAEL Office
Email: info@kpsystems.com
Tefen Industrial Park, Tefen 24959
Tel: 972-4-987-3066 Fax: 972-4-987-3692
USA Office:
KP ELECTRONICS INC.
Email: info@kpelectronics.com
415 Sargon Way Suite F Horsham PA 19044
Tel: (215) 442-7460 Fax: (215) 442-7461
P.N.: Book 139 Rev: New Approved: Dror H.
Pg.1 of 2 27Apr2015
Introduction
The following communication parameters
can be programmed or modified:
 Protocol
 Station address
 System
 Group
 Number of words (in a burst)
 Alarm repetitions
 Test repetitions
 Periodic test (hours: min)
 Parity
 Input delay
 Input polarity
 Transmit frequency (MHz)
Preparing for Programming
Before installing the ATSU100SD™ on
site, perform the following actions:
 Connect the ATSU100SD™ to the
GUP5000™ utility program
 Change Devices
 Load Device Parameter Values
 Change Device Parameter Values
 Update Parameter Value Changes
 Confirm Parameter Value Changes
 Perform SELF-TEST
Connecting ATSU100SD™ to GUP5000™
Connect ATSU100SD™ to a PC using
1.
the RSINT002™ adaptor (see
Figure 1).
2. Click StartPrograms
KP UtilitiesGUP5000, or click
shortcut.
The GUP5000™ main screen opens,
showing the device type, version, and
suitable default parameters.
PC
ATSU100SD
RSINT002
USB 6-pin
486 or higher
J3
cable Adaptor cable
Figure 1: ATSU100SD™ PC Connection
Configuration
Changing Devices
Various KP devices can be programmed
using the GUP5000™ utility software.
When started, the GUP5000™ utility
software program automatically connects
to the device currently connected to the
PC.
TM