Husqvarna TC 242T Operator's Manual page 36

Problem
There is loss of power.
There is vibration in the product.
The battery does not charge.
36
Cause
The product is operated at too high
forward or rearward speed when
you cut grass.
The throttle control is in the choke
position.
There is build-up of grass, leaves
or unwanted material under the
cutting deck.
The air filter is dirty.
The engine oil level is too low.
The engine oil is dirty.
The spark plug is defective.
The fuel filter is dirty.
The fuel in the fuel tank is bad.
There is water in the fuel.
The spark plug wire is loose.
The air intake or the cooling fins
on the engine are blocked.
The muffler is clogged or dam-
aged.
There is loose or damaged wiring.
The engine valves are not adjus-
ted correctly.
The blades are loose.
One or more of the blades are
damaged or not balanced.
The engine is loose.
The main fuse is defective.
The battery is defective.
The charging cable is disconnec-
ted.
The connection at the cable con-
nectors on the battery terminals is
bad.
Action
Use slower speed.
Put the throttle control in the fast
position.
Clean the cutting deck.
Clean or replace the air filter.
Do a check of the engine oil level.
Fill with engine oil if it is necessa-
ry.
Replace the engine oil.
Replace the spark plug.
Replace the fuel filter.
Replace the fuel in the fuel tank.
Remove all fuel from the fuel tank
and the carburetor. Fill the fuel
tank with new fuel and replace the
fuel filter.
Connect and tighten the spark plug
wire.
Clean the air intake and the cool-
ing fins on the engine.
Clean or replace the muffler.
Do a check of all wiring.
Speak to an approved service
agent.
Tighten bolts on the blades.
Balance the blades or replace the
blades.
Tighten the engine bolts.
Replace the main fuse.
Replace the battery.
Connect the charging cable.
Do a check of the battery connec-
tions.
2009 - 003 - 10.04.2023