Raymarine Base Station Installation And Commissioning Manual page 15

LifeTag Installation & Commissioning Guide
Fitting Alarm buzzer
Locating
Securing
1.
Secure bracket to buzzer
4.
Countersink the pilot holes
to prevent damage to the
mounting surface.
Figure 15 - Fitting buzzer
Connecting system
Important:
When connecting any part of the system, refer to the appropriate diagrams under
Connecting Base Station (above) to ensure you connect correctly
When you have secured the Base Station and Alarm buzzer, connect the Base Station:
• Either to SeaTalk, or to a separate 12 V power supply.
• To the Alarm buzzer.
If you want to use the switched 12 V output from the Base Station, connect as described in
Alarm buzzer
(see )
Figure 8
Optional 12 V output
during alarm condition
(see
Figure 9
Figure 16 - Summary of system connections
2.
Mark holes for fixing
screws.
Base Station
(see
Figure 5
Switch
)
3.
Drill two
pilot holes.
5.
Secure the alarm buzzer with the
No. 8 screws provided.
)
Either
Connect to SeaTalk
bus (see
5 A Fuse
or
Connect to 12 V dc power
source (see
11
inch (3.5 mm)
1 /
8
Figure 9
)
Figure 6
)
Figure 7
D8981-3
.