10
Fitting procedures
When you are satisfied that your LifeTag system will give satisfactory coverage aboard your boat:
• Fit the Base Station and Alarm buzzer, as described in
connect up your system. A summary of system connections is given in
• Fit one of the non-rechargeable, lithium CR2 3V batteries into each Tag as detailed in
Base Station
Before you permanently install a Base Station, carry out a site survey (as detailed on
you are fitting it to give satisfactory coverage.
1.
Remove cover
2
1
3. Drill two
7 /
64
holes for the fixing screws
5.
Use two No. 6 screws to secure the
Base Station to the mounting surface
Figure 14 - Fitting Base Station
inch (2.5 mm) pilot
LifeTag Installation & Commissioning Guide
Figure 14
Figure 15
and
Figure 16
2.
Mark holes for the fixing screws
4. Countersink the pilot holes to
prevent damage to the mounting
surface
6. Replace cover
respectively, then
.
Figure 10
.
Page 6
) to ensure