Installation And Wiring - Ariston 3319483 Installation And Operating Instructions Manual

RECEIVER (wireless version)
WARNING
Install the receiver outside the boiler and well
away from electromagnetic fields (e.g.: tele-
vision set, computer, refrigerator, microwave
oven), as these could affect the operation of
the device. Take extra care when positioning
the device near lifts, stairways and metal wall
structures, as these may have an isolating
effect with regard to signal transmission and
reception.
Inside a typical residential building, the two
devices must communicate reliably within a
30 m radius.
The signal strength of the Receiver depends
on the number of walls and ceilings separat-
ing it from the timer-controlled thermostat.
After selecting the position of the receiver,
verify whether the communication with the
timer-controlled thermostat is satisfactory.
NOTE: The connection between the re-
ceiver and the timer-controlled thermostat
(included in the same package - Fig. A) is
pre-configured by default, thus it must be in-
stalled in the same place. This makes the in-
stallation process straightforward and quick.
If the products are replaced or exchanged
with other packages, perform the recog-
nition procedure according to the instruc-
tions indicated in the "Recognition proce-
dure" paragraph.

INSTALLATION AND WIRING

- Separate the mounting base from the top part (Fig. 1).
- Fix the receiver base to the wall in the chosen position, using the plugs and screws supplied
with the kit, and insert the cable through the relevant cable opening (Fig. 2).
- Disconnect the boiler from the power supply.
- Connect the receiver's terminal to terminal TA1 on the boiler PCB and connect the power
supply cables (Fig. 3).
- Position the receiver on the base and turn the receiver by pressing against the wall (Fig. 4).
- Power the boiler.
1
B
L
N
2
L B
N
3
L B
N
L
N
230 V - 50 Hz
220V
SE TNK SOLT A1
1
4
GB / 33