One for All URC1281 Manual page 4

SETUP
The Essence 8 remote is pre-programmed to control some of the most
popular devices out of the box. If you have one of the following devices
try the putting the batteries in and pressing the device key, and then
press a few keys to see if the remote works your device:
Device Key To Press
If your device is not one of those listed above, or you have extra
devices to set up, there are 2 ways to do this. The easiest is SimpleSet
which is used for the common brands and devices.
SIMPLESET
If the brand of your device is shown in the SimpleSet picture pointing
to a key, you can use the SimpleSet system described in this section,
please locate the brand of your device and note the key associated
with it.
To set up your device:
1.
2.
3.
4.
5.
6.
7.
• If you find one or more keys do not work as you expect, start again at
step 2 – the remote will start with the next code in the memory.
713430_1-3_21T_Printfile_URC1281_ESSENCE_8_RDN1150323.indd 4 713430_1-3_21T_Printfile_URC1281_ESSENCE_8_RDN1150323.indd 4
TV
OTT
STB
AUD
AUX
BLU
DVD
BAR
Turn on your device (not on standby) and point the Essence
remote towards it. If you are setting up a Streaming device,
make sure a movie or TV show is playing.
Press the Device key you wish to set up (for
example TV).
Hold down the Setup key until the LED under the
Device key blinks twice.
Hold down the digit for your brand and device as
listed in the tables above - e.g. 7 for a Samsung TV.
For all devices except OTT the remote will send the Power key
every 3 seconds, for a streaming box the remote will send the
Play/Pause function.
As soon as your device reacts by turning off or Pausing
(Streaming box only) release the digit.
The LED will blink twice and the remote should now operate
your device.
Device controlled
Samsung TV
Roku Streaming Box
Sky Q Box
Onkyo Receiver
Vestel TV
Samsung Blu-ray Player
Sony DVD Player
Samsung Sound Bar
4
22-03-2023 11:51 22-03-2023 11:51