Samsung WW9 TA Series User Manual page 52

Troubleshooting
Problem
Fills with the wrong
water temperature.
Load is wet at the
end of a cycle.
Leaks water.
Has odours.
52 English
WW80TA046AX_04218T-01_EN.indd 52
• Fully open both taps.
• Make sure the temperature selection is correct.
Make sure the hoses are connected to the correct taps. Flush
•
water lines.
• Make sure the water heater is set to supply a minimum of
49 °C hot water at the tap. Also, check the water heater
capacity and recovery rate.
• Disconnect the hoses and clean the mesh filter. The mesh filter
may be clogged.
• While the washing machine fills, the water temperature may
change as the automatic temperature control feature checks
incoming water temperature. This is normal.
• While the washing machine fills, you may notice just hot and/
or just cold water going through the dispenser when cold or
warm temperatures are selected.
This is a normal function of the automatic temperature
control feature as the washing machine determines the water
temperature.
• Use the High or Extra High spin speed.
• Use high efficiency (HE) detergent to reduce oversudsing.
• Load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
• Make sure the drain hose is not kinked or clogged.
• Make sure the door is properly closed.
• Make sure all hose connections are tight.
Make sure the end of the drain hose is correctly inserted and
•
secured to the drain system.
• Avoid overloading.
• Use high efficiency (HE) detergent to prevent oversudsing.
• Check the drain hose.
- Make sure the end of the drain hose is not placed on the
floor.
- Make sure the drain hose is not clogged.
• Excessive suds collect in recesses and can cause foul odours.
• Run cleansing cycles to sanitize periodically.
• Clean the door seal (diaphragm).
• Dry the washing machine interior after a cycle has finished.
Action
2022/7/13 9:56:58