Safety During The Installation - TEXA TMD MKG SA Manual

3.5 Safety during the Installation

Safety Measures:
• Follow the indications provided in the vehicle's manual carefully to disassemble the plastic
parts and the access to the compartments.
• Do not compromise in any way the quality of the electrical and mechanical OEM wiring.
• Make sure the electric cables, the wiring in general, the fuel hydraulic pipes and the safety
pneumatic devices of the vehicle are not damaged during the installation.
• Do not change the current flow of an OEM circuit by cutting it off, increasing it or mechanically
changing it cables if not permitted by the vehicle manufacturer.
Safety Measures:
• Inform the driver that the device must not be moved in any way or for any reason from the
location where it was installed.
Safety Measures:
• Do not install the device near magnetic sources.
Safety Measures:
• Restore any OEM device (e.g.: covers, compartments, plastic parts, seals).
• Replace the fastening elements that are damaged.
The installation of the device was carefully tested by qualified
personnel in TEXA.
You must follow some indications provided by the vehicle
manufacturer in order to install the device correctly.
The device must be installed so as to ensure it can work
correctly and safely.
Make sure the installation does not interfere with the operation
of the vehicle controls.
Make sure the product's position does not compromise safety
when driving the vehicle.
MAGNETIC SOURCES (for example: loudspeakers) MAY
ACTIVATE THE DEVICE INAPPROPRIATELY, REDUCING THE
BATTERY LIFE.
At the end of the installation, you must restore the initial
conditions of the vehicle.
11