Table of Contents
Advertisement
Installation
Unpacking
All transit bolts and packing must be removed before using the appli-
ance.
Using a spanner,
unscrew
remove the 2 rear
bottom
screws.
Slide out the 2
plastic pins. Lay
the machine on
its back, taking
care
not
squash the hoses. This can be avoided by
placing one of the corner packing pieces
between the machine and the floor.
Remove the polystyrene block from the
bottom of the machine and release the
two plastic bags.
Carefully slide out the left-hand bag removing
it towards the
right and then
downwards.
Slide out the right-
hand bag remov-
ing it towards the
left and then
upwards.
Set the machine
upright and
remove the
remaining rear
screw. Slide out
the relevant pin.
Plug the open
holes with the
plugs which you
will find in the plastic bag containing the instruction booklet.
You are advised to keep all transit devices so that they can be refitted if the
machine ever has to be transported again.
and
025
to
P1126
P1128
P0001
1
2
3
P1124
P1127
P0002
85
Advertisement
Table of Contents
