Table of Contents
Advertisement
Problem
The machine vibrates or is
noisy
The door will not open
Spinning starts late or the
machine does not spin
Possible cause
The transit bolts have
not been removed.
The feet have not been
adjusted.
There is little laundry in
the drum.
The programme is still
running and the drum
is turning.
The water level is above the
bottom edge of the door.
The machine is heating the Wait until the end of the
water.
The unbalance detection
device that prevents
excessive vibration during
spinning has cut in.
Something not working?
Solution
Check that the machine
has been unpacked as
described in the Installation
section.
Carefully level the machine.
Correct operation of the
machine is not affected.
Wait until the end of the
programme before opening
the door.
Before opening the door,
the water must be emptied
out.
heating phase.
If the laundry is not evenly
distributed inside the drum
at the beginning of the
spin cycle, the machine
detects this and tries to
redistribute it more evenly
by means of a few drum
rotations.
Only when the laundry is
more evenly distributed
will the spin cycle be
performed, at a lower speed,
if the laundry is not evenly
distributed.
If, after about 10 minutes,
the laundry is still tangled,
the machine will not spin.
Therefore, if the laundry is
still wet at the end of the
cycle, it is advisable to
redistribute it manually
inside the drum and to
select the spin programme.
79
Advertisement
Table of Contents
