Advertisement
3.1.6. When the charge is complete the red LED and the green LED will show a steady
light to indicate charging is complete. The battery pack is now ready for use.
Note: The first charge and several subsequent charges will take longer than usual until
the battery reaches optimum performance, after that the usual charge time will take
approximately 80 minutes.
3.1.7. After removing the battery, disconnect the charger from the mains supply and
store in the carry case.
WARNING! Ensure you read, understand and apply safety instructions before use.
3.2
USING THE WRENCH
3.2.1
Use only impact sockets which are specifically designed for use with an impact wrench. The use of normal chrome vanadium sockets
is dangerous since these are more brittle and are liable to shatter.
3.2.2
Fit the socket to the wrench by snapping it onto the square drive (fig 1.1).
3.2.3
Fit the battery pack to the wrench by aligning the tongue on the battery with the groove in the housing and slide into place. Ensure
that the battery pack is firmly located, you will hear an audible click when it has locked into position.
3.2.4
Select the required direction of rotation. To change direction, push switch (fig.1.2) to the left or right. Familiarise yourself with this
operation before use. DO NOT attempt to change the direction of rotation whilst trigger (fig.1.5) is depressed.
When the wrench is not in use, use the same switch to lock off the trigger by placing the switch in the middle position.
3.2.5
When tightening, release the trigger as soon as the impact sound is heard. Take care not to over-torque small fixings.
Note: Speed of wrench is controlled by trigger depression.
Note: On critical fixings always check the torque with a torque wrench according to the product or vehicle manufacturer's
guidelines.
4. MAINTENANCE
4.1
CLEANING
Keep the outer case of the wrench clean and free from grease. DO NOT wash with water or use solvents or abrasives. Use a slightly
dampened cloth. For any other service or maintenance, contact your authorised service agent.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of
products containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance
scheme.
Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without
prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
01284 703534
sales@sealey.co.uk
Original Language Version
fig.2
www.sealey.co.uk
CP1440MH Issue:1 - 03/07/17
Advertisement
