Advertisement
Available languages
Available languages
PRECAUTIONS FOR SAFETY
● Do not install, repair, open or remove the cover. It may expose you to
dangerous voltages. Ask the dealer or the specialist to do this.
● Turning off the power supply will not prevent potential electric shock.
● The appliance shall be installed in accordance with national wiring
regulation.
DANGER
● Means for disconnection from the supply having a contact separation of
at least 3 mm in all poles must be incorporated in the fi xed wiring.
● Do not expose your body directly to cool air for a long time.
● Do not insert your fi nger or any article into the air inlet/outlet.
● When an abnormality (burning smell, etc.) occurs, stop the air
conditioner and disconnect the power supply or turn off the breaker.
● This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible
for their safety.
WARNING
● Children should be supervised to ensure that they do not play with the
appliance.
● Do not use any refrigerant different from the one specifi ed (R410A) for
complement or replacement. Otherwise, abnormally high pressure may
be generated in the refrigeration cycle, which may result in a failure or
explosion of the product or an injury to your body.
● Do not wash the unit with water. It may cause an electric shock.
● Do not use this air conditioner for other purposes such as preserving
food, breeding animal, etc.
● Do not step or put anything on the indoor/outdoor unit. It may cause an
injury or damage the unit.
● Do not touch aluminium fi n because it may cause an injury.
● Before cleaning the unit, turn off the main switch or the circuit breaker.
● When the unit won't be used for a long time, turn off the main switch or
CAUTION
the circuit breaker.
● It is recommended that maintenance be performed by a specialist when
the unit has been operated for a long time.
● The manufacturer shall not assume any liability for the damage caused
by not observing the description of this manual.
1
INDOOR UNIT DISPLAY
1 TIMER (White)
2 OPERATION (White)
2
PREPARATION BEFORE USE
Preparing Filters
1. Open the air inlet grille and remove the air fi lters.
2. Attach the fi lters. (see detail in the accessory sheet).
Loading Batteries (when use wireless operation.)
1. Remove the slide cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (–) positions.
Clock Setup
1. Push
by tip of the pencil.
If timer indication is fl ashing, go to the next step 2.
2. Press
or
3. Press
: Set the time.
Remote Control Reset
Push
by tip of the pencil or
1. Remove the batteries.
2. Press
.
3. Insert the batteries.
3
AIR FLOW DIRECTION
FIX
Press
1
the desired vertical direction.
SWING
2
Press
automatically and press again to stop.
For horizontal direction, adjust
3
manually.
Note:
●
Do not move the louver manually by others.
●
The louver may automation positioning by some operation mode.
1118350203_EN.indd 2
1118350203_EN.indd 2
: adjust the time.
: Move the louver in
: Swing the air
4
REMOTE CONTROL
1 Infrared signal emitter
2 Start/Stop button
3 Mode select button (MODE)
4 Temperature button (TEMP)
5 Fan speed button (FAN)
6 Swing louver button (SWING)
7 Set louver button (FIX)
8 On timer button (ON)
9 Off timer button (OFF)
! Setup button (SET)
" Clear button (CLR)
# Memory and Preset button (PRESET)
$ One-Touch button (ONE-TOUCH)
% High power button (Hi-POWER)
& Power selection button (POWER-SEL)
( Quiet button (QUIET)
) Comfort sleep button (COMFORT SLEEP)
~ Filter reset button (FILTER)
+ Set clock button (CLOCK)
, Check button (CHECK)
- Reset button (RESET)
Note:
●
The provided Remote Controller is a wireless type, which also can be
used as a wire. Please see "How to Connect The Remote Controller
for Wired Operation", located in installation instruction, in case of wired
control is required.
●
In wire operation, remote controller will return to initial condition (PRESET,
TIMER and CLOCK will return to initial condition) when user shutdown
power supply of Air conditioner.
5
ONE-TOUCH
Press the "ONE-TOUCH" button for fully automated operation that is
customized to the typical consumer preferences in your region of the world.
The customized settings control temperature air fl ow strength, air fl ow
direction and other settings to provide you alternate contact with "ONE-
TOUCH" of the button. If you prefer other settings you can select from the
many other operating functions of your Toshiba unit.
ONE-TOUCH
Press
: Start the operation.
6
AUTOMATIC OPERATION
To automatically select cooling or fan only operation
MODE
1. Press
: Select A.
2. Press
: Set the desired temperature.
FAN
3. Press
: Select AUTO, LOW , LOW+
MED+
, or HIGH
.
7
COOLING / FAN ONLY OPERATION
MODE
1. Press
: Select Cool
or Fan only
2. Press
: Set the desired temperature.
Cooling: Min. 17°C, Fan Only: No temperature indication
FAN
3. Press
: Select AUTO, LOW , LOW+
MED+
, or HIGH
.
8
DRY OPERATION
For dehumidifi cation, a moderate cooling performance is controlled automatically.
MODE
1. Press
: Select Dry
.
2. Press
: Set the desired temperature.
9
Hi-POWER OPERATION
To automatically control room temperature and airfl ow for faster cooling
operation (except in DRY and FAN ONLY mode)
Hi POWER
Press
: Start and stop the operation.
1
#
4
2
6
3
5
SWING
FAN
7
(
$
ONE-TOUCH
FIX
QUIET
&
%
POWER-SEL
Hi POWER
"
COMFORT
8
9
SLEEP
!
)
,
-
+
~
, MED
,
.
, MED
,
1/28/2559 BE 17:15
1/28/2559 BE 17:15
Advertisement
