ICON Health & Fitness Pro-Form Carbon T10 User Manual page 14

12. Carefully slide the Upright Crossbar (40)
between the Left and Right Uprights (85, 86).
Attach the Upright Crossbar with the four
5/16" x 3/4" Screws (8) that you removed in step
5, and four 5/16" Star Washers (12); start all
four Screws, and then tighten them.
13. Note: If the treadmill is assembled on a
smooth surface, it may roll forward during
this step.
Raise the Frame (60) to the upright position.
IMPORTANT: Do not raise the Frame past the
vertical position. Have a second person hold
the Frame until step 14 is completed.
Remove the two 5/16" x 3/4" Screws (8) from the
Latch Crossbar (31).
Orient the Latch Crossbar (31) as shown. Make
sure that the "This side toward belt" sticker
(I) is facing the treadmill. Attach the Latch
Crossbar to the brackets (J) on the Frame (60)
with the two 5/16" x 3/4" Screws (8) and two
5/16" Star Washers (12).
12
86
8
12
13
J
12
8
60
14
85
40
8
12
I
31
J
12
8