Advertisement
Set Watering Frequency
Turn the knob to the desired frequency. It will begin after the frequency has been set for 2 seconds. When the knob is turned to the
new setting for 2 seconds, the frequency resets to the new one. There are 11 frequency options:
(1) By hour(s): 1, 2, 3, 4, 6, 8, 12, 24, 48, or 72 hours
(2) By week: Weekly (1-start per week)
*Frequency setting must be longer than duration setting.
Set Watering Run Time
Turn the knob to the desired run time. Watering will be controlled by the frequency and run time settings, then it will close
automatically. The run time dial has 10 options:
(1) OFF: the valve will always be close when the knob is in this setting.
(2) ON: the valve will always be open when the knob is in this setting.
(3) By min(s): 1, 3, 10, 15, 20, 30, 45, 60, 90, or 120 minutes
(4) Manual watering: To manually open the valve, turn the knob to "ON". Water will continuously flow until the knob is turned to "OFF"
(always closed) or other desired setting.
Start Time Delay Function
You can easily delay the start time of the current watering program by pushing the "Delay Start" button. After the watering program is
set, push the "Delay Start" button until the indicator is "red". Once the red indicator appears, push the button once for each hour you
want to delay the start, up to 12 hours max. Every time the button is pushed, the indicator will flash in "green" and delay the start by
one hour. For example, if you want to delay the program for 5 hours, push the button 5 times (the indicator will flash in green 5 times
as well). Once the red indicator is off, the start time setting is complete.
*Be sure to complete the programming process within ONE minute.
*Every time the "Delay Start" button is pushed and the indicator turns red, the start time program has been reset.
TROUBLESHOOTING
No watering operation
No manual operation
Faucet or hose is leaking
Low Battery Power
Warning: Do not use a wrench to tighten the swivel faucet coupling. It might cause damage to the swivel coupling of the timer.
© 2018 The Toro Company
All manuals and user guides at all-guides.com
• Make sure the faucet tap is turned on (open position)
• Check "Run Time" knob is not at the "OFF" position
• Check the condition of the battery power
• Check "Run Time" knob is at the "ON" position
• Check the condition of the battery power
• Check if the washer in the swivel coupling is included or missing
• Tighten the hose swivel couplings
• Check if the low battery indicator is red
• If red indicator is lit, change the batteries and reset the program
Part No. 373-0969 Revision A
Advertisement
