Steering Column
Opening
9
• Insert the handlebar steering column down through the
opening in the front end of the vehicle. Be sure to fit the
steering column through the opening in the base plate and
the hole in the steering linkage (underneath the vehicle).
• Push to "snap" the handlebar into the vehicle.
10
• While holding the handlebar in place, carefully turn the
vehicle over.
• Make sure the end of the steering column is through the
hole in the steering linkage.
• Fit the steering column cap onto the end of the steering
column.
R8548pr-0920
ASSEMBLY
BOTTOM VIEW
BOTTOM VIEW
BACK VIEW
Steering
Column
Cap
11
• Insert a #8 x
3
/
" screw through the large opening in
4
the steering column cap and into the hole in the
steering column.
Tighten the screw.
Clip
12
• Slide the clip (open side down) under the end of the
steering column, as shown.
9