Asko D5904 Operating Instructions Manual page 21

Max. 950 mm
Min. 350 mm
Figure 1
Max. 3 m
Figure 2
Max. 950 mm
Min. 350 mm
Figure 3
CONNECTION TO WATER SUPPLY
Use only the supply hose provided with the dishwasher. Do not
re-use old hoses or other spare supply hoses.
The supply pipe must be fitted with a stopcock. The stopcock must
be easily accessible, so that the water can be shut off if the
dishwasher has to be moved.
Once the installation is complete, the stopcock should be opened
to allow the pressure to settle for a while and to check that all
connections are tight.
Connect to cold water...
If you use oil or electricity to heat your home.
Min. 14 mm
Max. 950 mm
Min. 350 mm
Connect to hot water (max. 70 °C)...
If you use district heating, solar power or geothermal power to
heat your home. Choosing a hot water connection cuts program
times and reduces the dishwasher's electricity consumption.
NOTE!
Connecting a dishwasher to the water supply via certain types
of pressure limiting valves may restrict the water supply!
This may cause F:12 error code/ Water inlet fault to be displayed.
ELECTRICAL CONNECTION
Information about the electrical connection can be found on the
serial number plate This specification must match the electricity
supply.
Dishwashers fitted with a plug must be connected to an earthed
socket.
The electric wall socket must be placed outside of the installation
area to be easily accessible after installing the dishwasher. Do not
use an extension cord!
NOTE!
Repairs and maintenance must be carried out by a qualified
professional.
21