Bluetooth Connection Lock (Bt Lock) - LG SK4D Owner's Manual

,
Note
y When using Bluetooth technology, you have
to make a connection between the unit and
the Bluetooth device as close as possible and
keep the distance.
However it may not work well in the case
below :
- There is an obstacle between the unit and
the Bluetooth device.
- There is a device using same frequency
with Bluetooth technology such as a
medical equipment, a microwave or a
wireless LAN device.
y If Bluetooth connection does not work well,
try pairing it again.
y The sound may be interrupted when the
connection has interference by the other
electronic waves.
y Pairing is limited to one Bluetooth device per
unit and multi-pairing is not supported.
y Depending on the type of the device, you may
not be able to use the Bluetooth function.
y You can enjoy Bluetooth function using
smart phone, MP3, Notebook, etc..
y The more distance between the unit and the
Bluetooth device, the lower the sound quality
becomes.
y Bluetooth connection will be disconnected
when the unit is turned off or the Bluetooth
device gets far from the unit.
y When Bluetooth connection is disconnected,
connect the Bluetooth device to the unit
again.
,
Note
y When Bluetooth device is not connected, BT
(Bluetooth) LED blinks.
y When you connect Bluetooth device (iOS
device etc.) to this unit or operate the device,
the volume level can be synchronized with
each other.
y You can control Bluetooth device using
C/V (Skip) and dM (Play/Pause)
buttons on the remote control.
y If you change to another function after
connecting Bluetooth, Bluetooth connection
will be disconnected. And you return to
Bluetooth function, Bluetooth connection
will be connected automatically.
BLUETOOTH connection lock
(BT lock)
You can limit Bluetooth connections to only
BT (Bluetooth) and LG TV function to prevent
unintended Bluetooth connections.
Press and hold AUTO POWER ON on the remote
control for about 2 seconds to turn on this function
in BT (Bluetooth) function. Then the standby LED
(Red) blinks once. After that, this function is enabled.
To turn off this function, press and hold AUTO
POWER OFF on the remote control for about
2 seconds in BT (Bluetooth) function. Then the
standby LED (Red) blinks once. After that, this
function is disabled.
,
Note
Even if you set up Bluetooth connection lock
to On, this sound bar turns on by Auto Power
function. Turn off Auto Power function to
prevent it. (Page 18)
Operating 21
3